Can you manufacture gears to our drawing / sample?
Yes. We can manufacture gears from your drawing or from a physical sample. A complete drawing is usually the fastest route; a sample is most useful when you want match-fit verification or the drawing is incomplete.
When a drawing is enough
If your drawing includes tooth geometry, tolerances, and material/heat-treat requirements, we can quote → make samples → then move to bulk after approval. Clear “first article” validation is commonly used to confirm the first produced part meets requirements before scaling up.
When a sample helps
A sample helps when:
• Tooth data or tolerances are missing on the drawing
• You’re replacing an existing part and need match-fit to mating parts
• You want to benchmark wear/noise/backlash performance using a “known good” reference
What we need to quote accurately
1. Drawing (2D/3D) or sample + photos of mating parts
2. Gear data (module/DP, teeth, pressure angle, helix angle if any, face width)
4. Material & heat treatment (hardness/case depth targets if applicable)
5. Accuracy/inspection requirements (dimensional + gear profile/lead if required)
6. Quantity plan + Incoterms (FOB/CIF/DDP)
Quick table
| Input | Typical result | Notes |
| Complete drawing | Drawing + sample | Lowest ambiguity |
Drawing + sample | Lower risk for first order | Best for match-fit |
Sample only | Extra measurement & confirmation | More time upfront |